STARTING/CHARGING – Hyundai Elantra GT 2004 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Hyundai Elantra GT 2004

List of elements for Charging Wiring Diagram for Hyundai Elantra GT 2004:

• (in left front corner of engine compt) engine compartment relay & fuse box
• (w/ trip)
• (w/o trip)
• Battery
• Battery ground
• Body ground
• Charge indicator
• E20-2
• Fuse 10a
• Fusible link (batt) 120a
• Fusible link (ecu) 20a
• Generator
• Headlights system
• Hot in on or start
• I/p-b
• I/p-h
• Instrument cluster
• M09-1
• M09-2
• M10-1
• Passenger compartment junction block (under left side of dash, near kick panel)
• Pre- excitation resistor
• Red
• Starting circuit

Starting Wiring Diagram for Hyundai Elantra GT 2004

List of elements for Starting Wiring Diagram for Hyundai Elantra GT 2004:

• A/t
• Acc
• Battery
• Battery ground
• Body ground
• Burglar alarm relay (below left side of dash, beside passenger compt relay block)
• Ec05
• Engine compartment relay & fuse box (in left front corner of engine compt)
• Etacm (under center of dash, below radio)
• Fuse 10a
• Fusible link (ign) 40a
• G15
• I/p-e
• I/p-g
• Ignition switch
• Joint connector e55
• Lock
• M/t
• M25-3
• N d
• Nca
• Passenger compartment junction block (under left side of dash, near kick panel)
• Pnk
• Power distribution system
• Red
• Run off
• Start
• Start relay
• Start solenoid
• Starter clutch pedal position switch (on clutch pedal bracket)
• Starter motor
• Transaxle range switch (on top left side of transaxle)