BODY CONTROL MODULES – Hyundai Elantra GT 2004 – SYSTEM WIRING DIAGRAMS

BODY CONTROL MODULES

Body Control Modules Wiring Diagram for Hyundai Elantra GT 2004

List of elements for Body Control Modules Wiring Diagram for Hyundai Elantra GT 2004:

• Anti-theft system
• B/alarm relay control
• Chime bell control
• Code save
• Computer data lines system
• Crash input
• Defogger relay control
• Defogger switch on input
• Defogger system
• Door locks system
• Door switch (all)
• Door warning switch input
• Dr lock rly control (lock)
• Dr lock rly control (unlock)
• Driver door unlk relay ctrl
• Engine rpm input signal
• Etacm (under center of dash, below radio)
• Exterior lights system
• Front fog lamp relay
• Fuse 2 10a
• Fuse 24 10a
• Fuse 25 15a
• G11 (behind center of dash)
• Ground
• Hazard relay control
• Headlamp relay (low)
• Headlights system
• Hood switch
• Hot at all times
• Hot in on
• Hot in on or start
• I/p-g
• I/p-h
• I/p-j
• Ignition key illumination & door warning switch
• Illum
• Int
• Int (time)
• Interior lights system
• J/c m36 (left side of dash)
• Key hole illum control
• Key switch
• Left front door switch
• Left front lock/unlock input
• M25-1
• M25-2
• M25-3
• Memory power
• Nca
• On input
• On/start input
• Passenger compartment junction block (under left side of dash, near kick panel)
• Pnk
• Power window control relay
• Power windows system
• Pre- excitation resistor
• Rear door/tailgate input
• Red
• Right front door switch
• Right front lock/unlock input
• Room lamp control
• Seat belt indicator ctrl
• Seat belt switch
• Siren control
• Starting/charging system
• Tail lamp relay
• Trunk unlock switch
• Trunk/tailgate switch input
• Warning system
• Washer input
• Wiper motor relay control
• Wiper/ washer system