SUPPLEMENTAL RESTRAINTS – Ford Ranger 1998 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Ford Ranger 1998

List of elements for Supplemental Restraint Wiring Diagram for Ford Ranger 1998:

• (behind center of dash) generic electronic control module (gem)
• (dlc) (fastened to bottom of dash, near steering column)
• (engine harness, near breakout to horns)
• (left side of upper radiator support)
• (main harn, near breakout to rabs module)
• (main harn, near breakout to i/p fuse panel)
• * pin shorting bar is engaged when module connector is disconnected
• Air bag electronic crash sensor (behind right side of kick panel)
• Air bag feed
• Air bag fuse 5 10a mini
• Air bag ind
• Air bag lamp
• Air bag ret
• C216
• C221
• C250
• C256
• Clock- spring assembly
• Connector pins not shown are not used
• Data link con
• Data link connector c209
• Driver's air bag
• Engine compartment fuse/relay box (left rear of engine compt)
• Fuse 15 7.5a mini
• Fuse 2 7.5a mini
• G108
• Gem module
• Ground
• Hot at all times
• Hot in run
• Hot in run or start
• I/p fuse panel (behind left side of dash)
• Instrument cluster
• Left primary crash sensor (left front of vehicle, on left front of lower radiator support)
• Nca
• Off
• Ohms
• Pad indicator
• Pad input
• Passenger's air bag
• Passive airbag deactivation (pad) module (behind center of dash)
• Power (bat)
• Power (run)
• Right primary crash sensor (right front of vehicle, on right front of lower radiator
• S156
• S205
• S225 dash harness, near breakout to gem
• S250
• Sensor feed
• Shorting bar
• Support)